PERFECTLY EASY! REPAIRING DAMAGED VINYL FLOORING by Pamela Cole Harris
So you got the perfect refrigerator. For the perfect kitchen.
Miles and miles of virgin stainless steel. Perfect width. A
virtual soda fountain in the door. And as your husband (just
a shade less than perfect) pulls it across the floor to that
perfect spot way on the other side of the kitchen, you hear a
slight ripping sound. Can stainless steel rip? Not likely. Your
husband gives it another pull. The same sound. Looking down to
investigate (as any perfect homeowner would), you discover that
your perfect vinyl flooring now has a wide, perfectly-jagged
tear. Yikes!
Here is how you can make the perfect repair:
1. Measure the extent of the damage. Width? Length?
2. Is your vinyl flooring relatively new? You should be able
to find the pattern at your local home-improvement or
flooring supply store. If your pattern is unavailable, you
may have to replace the entire floor.
3. Buy enough of the flooring to repair the damaged area and
a little extra to save for future repairs.
4. Cut a piece of the new flooring a bit larger than the
damaged area. A sharp utility knife should do the job
(handle with care!). Use a straight edge or ruler to help
keep the blade vertical.
5. Match the pattern of the new piece with the old at each
edge of the damaged area.
6. Take out your handy dandy duct or masking tape and tape the
new piece to the floor below. You don't want the new tile
to slip, so make certain you have taped it securely.
7. Ok. This is tricky. Use your knife to cut through both
layers of vinyl. Cut around the damaged area (make certain
you cut it just a bit bigger so that you will remove all
the damage).
8. Now remove the new vinyl on top and the piece of damaged
vinyl beneath. If you have difficulty removing the old
vinyl, a hair dryer works great to soften the adhesive!
9. Scrap away all of the old gunk (Gunk. That's a technical
term!) with a putty knife or an old mismatched table knife
(not a steak knife!). Be sure to sweep clean!
10. Using your putty knife, apply adhesive to the back of the
new piece of vinyl. Make sure your kitchen is well-
ventilated. That stuff can be harmful!
11. Press the new piece into place. It's best to start at the
center and work towards the edge to make certain all those
little air bubbles are worked out.
12. If you have excess adhesive around the edges, wipe it up
with a clean, damp sponge.
13. This is the fun part! Take your rolling pin (you DO have
a rolling pin, don't you?) and roll the patch firmly. You
will have to wipe the excess adhesive again.
14. Now you can let the adhesive dry (no dancing on it for
about 24 hours!).
Zowie! Now your perfect kitchen has returned! Wait! Is that a
perfectly awful footprint I see?
----------------------------------------------------------------
Pamela Cole Harris is an editor and writer with
35 years experience. Visit her website,
http://www.homeandgardenmakeover.com, for a free newsletter
with remodeling, home improvement and decorating ideas for the
financially challenged, creatively deficient and technologically
illiterate.
More articles on HOME
20 Ways to Warm Up Your Winter Nest
20 Ways One Person Can Change the World for Under 50 USD a Month
Calling all Packrats! How to Turn 'Stuff' into Style!
Five Easy Tricks for Handling Problem Rooms
Perfectly Easy! Repairing Damaged Vinyl Flooring
Ten Ways to do Tuscan on a Budget
Finishing Your Basement Walls: At Home with Furring, Shims and Plumb
Five Easy Steps For Arranging your Living Room Furniture
Five Keys to Remodeling on a Budget
Ten Ways to do Tuscan on a Budget
Five Easy Steps For Arranging your Living Room Furniture
368
|
|
|
|
